Camera Models
- How to configure AVT Manta/Prosilica GigE highspeed camerasSwing catalyst support AVT high-speed GigE machine vision cameras. These cameras connect to the computer through a gigabit network interface/cable and allow...
- Setting up FLIR BlackFly S GigE in Swing CatalystThis article covers how to use Spinnaker compatible GigE Vision cameras in Swing Catalyst.
- Setting up the Swing Catalyst Fox USB 3.0 camera(s)Guide to assembling and setting up Swing Catalyst Fox USB 3.0 cameras, including driver installation and configuration
- Setting up the Swing Catalyst Lynx GigE camera(s)Both the "Lynx" and "Fox" cameras are only supported in Swing Catalyst 9.8.2 or higher.
- How to setup Halcon for Swing CatalystThe release of Swing Catalyst 6.0 brings support for three of the most common machine vision standards.
- How to install AVT Manta/Prosilica GigE camerasTo setup and install GigE cameras you will require one or more free network ports in your computer.
- FLIR Camera warranty and service informationWarranty coverage and service information for FLIR cameras used with Swing Catalyst
- Find Which Standards Your Camera Supports for HalconUsually the manufacturer will mention what standards they support explicitly either in documentation or if the documentation or marketing material contain...
- How to set static IP on FLIR Blackfly GigE camerasEach camera and network adapter must have its own unique static IP address. For example, if you assign a static IP addresses to a cameras, ensure that the...
- How to set static IP on Lynx GigE camerasOnce the cameras have static IP addresses assigned to them you need to configure the network adapters you plan on using with a static IP. This needs to be...
- Configure Point Grey / FLIR GigE (Blackfly) CamerasGuide to configuring Point Grey / FLIR GigE Blackfly cameras with Swing Catalyst.
- How to configure IDS uEye GigE camera with Swing CatalystGuide to configuring IDS uEye GigE cameras with Swing Catalyst. For USB camera setup, see the IDS uEye USB article.
- How to use IDS uEye USB cameras with Swing CatalystThis support article describes the practical details of how to configure and use a IDS uEye USB camera.
- Setting up FLIR BlackFly S USB in Swing CatalystThis article covers how to setup and configure a Spinnaker compatible USB camera in Swing Catalyst.
- Use the Dragon (120 FPS) USB 2.0 CameraThis article covers how to setup and use the Dragon USB 2.0 camera with Swing Catalyst.
- How to upgrade or downgrade Fox / Lynx firmwareHow to upgrade or downgrade firmware on Swing Catalyst Fox and Lynx cameras
- How to use Point Grey / FLiR USB cameras with Swing CatalystNote: Camera control settings are limited to FlyCapture (Point Grey software).
- How to set up Basler GigE camera's with Swing CatalystEach camera and Ethernet card (NIC / Network interface controller) should be configured with static IP's on different subnets (and subnet mask)
- How to setup iDS uEye USB highspeed camerasThis support article will describe how to install and setup a USB 2.0 or 3.0 camera for use in Swing Catalyst.
- Setting up Ximea USB3 Vision camera's with Swing CatalystHow to set up Ximea USB3 Vision cameras with Swing Catalyst through Halcon: firmware, drivers, and camera exposure and frame rate settings.
- Using FLIR Blackfly S (Spinnaker) CamerasThis support article covers setting up FLiR Blackfly S cameras with Swing Catalyst 9.4.
- Upgrading the firmware on the FLIR Blackfly SThis article covers how to upgrade the firmware on the FLIR Blackfly S GigE BFS-PGE-04S2C-CS.
Last updated on